yamaha studio manager ls9 connection issues

Do NOT connect to the port on the router labeled “Internet” or “WAN”. Connect these cables to the router outputs ports ONLY (LAN ports). NOTE REGARDING ROUTERS: When connecting THROUGH a router, use a “Standard” Ethernet cable to the PC and either a “Standard” or “Crossover” cable to the LS9. (NOTE: Some of Yamaha’s other consoles require a crossover cable for direct connection to a PC). NOTE REGARDING DIRECT CONNECTION CABLES: You may use either a “Standard” Ethernet cable or a “Crossover” cable for a direct connection between an LS9 and a PC. NOTE 3: Click “Set Default” to make LS9 default console, other wise you must repeat these steps each time you launch Studio Manager. NOTE 2: If you have already set up your PC for control via a “wired” Ethernet connection or have already set up your PC for wireless connection, you will need to enter a different Static IP Address so the two do not conflict (i.e., 192.168.0.131). NOTE 1: It may be necessary to change this setting back to “Obtain an IP address automatically” in order to later connect to the Internet or certain networks. * Select “Console -> PC” or “PC -> Console” and click “OK”Īfter “Re-Synchronizing” is completed, you should be good to go! * Click on “Synchronization” and select “Re-Synchronizing” * Enter “Administrator Password”, if you have set one, (same as on the LS9) and click “OK” * Select identical (the same) “Input Port” and “Output Port” * Click on “File” and select “System Set Up” * Double-click on the LS9 Icon and open LS9 Editor * Select “MIDI Ports” and “check” identical (the same) “Input Port” & “Output Port” & click “Apply” Add “LS9” from “Device Editor” to the “Workspace” Select “File”, then “Setup” then “Modify Workspace” STUDIO MANAGER SETUP (steps with * may need to be repeated each time Studio Manager is launched) (i.e., Norton, Symantec, etc… & Turn off Windows Firewall. Click “OK” on “Internet Protocol (TCP/IP)” box Click “OK” on “Local Area Connection Properties” box

***YOU WILL USE THE NUMBER PROVIDED ON THE CONSOLE*** Select “Use the following IP Address” and enter a Static IP Address

Select “General” tab, scroll to and click on “Internet Protocol (TCP/IP)”

Right click on “Local Area Connection” and then click on “Properties” Click “Apply” then click “Save and Close” Enter “Device MAC Address” (Go to LS9 “Setup” screen. Enter “Device IP Address” (Go to LS9 “Setup” screen. Click on “New” button (The middle section should allow for data to be entered). Double click on the “DME Network Driver” Click on “Start” menu and then click on “Control Panel” Confirm that “DME-N Network Driver”, “Studio Manager”, & “LS9 Editor” are installed on your PC. Networking & Wireless Networking with LS9 & Windows XP

Yamaha studio manager ls9 connection issues